Yamaha XP7000

Specifications:
- Dynamic power: 1kHz 20ms nonclip 2ohms 1600W x 2
4ohms Bridge 3200W
- Output power: 1kHz 4ohms 1100W x 2
8ohms 750W x 2
8ohms Bridge 2200W
- Output power: 20Hz-20kHz 4ohms 950W x 2
8ohms 700W x 2
8ohms Bridge 1900W
70V line 625W x 2 / 8ohms
100V line -

General specifications:
- Total harmonic distortion: Less than 0.1% ( 20Hz-20kHz; Halfpower) , RL= 4ohms
- Intermodulation distortion: Less than 0.1% ( 60Hz: 7kHz= 4: 1; Halfpower)
- Frequency response: + 0dB, -1.0dB ( RL= 8ohms, 20Hz - 20kHz)
- S/ N ratio: 104dB
- Power band width 10Hz-40kHz
- Crosstalk: Less than -70dB
- Damping factor: More than 350
- Voltage gain: 32dB/ 26dB / 35.7dB ( + 4dBu)
- Input sensitivity: + 7.7dBu ( 32dB) , + 13.7dBu ( 26dB) , + 4dBu
- Maximum input voltage + 22dBu
- I/ O Connectors Line input / output ports: 2x XLR-3-31 type, 2x Euroblock connector
- Speaker output ports: 2x speakON, 2x 5-way binding post
- Control ports D-sub 15pin
- Processors: HPF ( 20Hz/ 55Hz/ OFF, 12dB/ Oct)
- Protection circuit: Load protection Power switch on/ off mute, DC-fault: Amplifier shuts down automatically. ( Operation not restored automatically) , Clip limiting ( THD e 0.5% )
- Amplifier protection: Thermal ( Mute the output; heatsink temp e 90° C; Operation not restored automatically) , VI limiter ( Limit the output, RL d 1ohm)
- Power supply protection: Thermal ( Amplifier shuts down automatically; heatsink temp e 100° C)